Backbox: 16 gauge aluminum. Wire access through .875" diameter knockouts on four sides and back. Water tight. Optional for surface conduit entry.
Backplate: 16 gauge aluminum
Cage: Standardized .375" or .5" diameter aluminum guard bars secured by hidden means to the frame. Standard square extruded bars. Standard configurations shown; custom spacing available.
Diffuser: Translucent white non-yellowing 100% virgin acrylic. Fully enclosed. Clear top and bottom [CLTB] is Standard with Uplight or/and Downlight. Optional Opaque top, bottom or both [OTB]. Optional Open [OPTB] top and/or bottom — Indoor Only. Optional [PF] perforated aluminum insert. Optional Aluminum Solid Shield Top/Bottom (No Light).
Painted Finish: Pre-treated highly durable oven baked polyester powder finish. Corrosion and Weather resistant. Standard [BK] Black, [BZ] Bronze, [Sv] Silvadillo or [WHT] white. Available Custom Colors [CC] are listed.
Gasketing: High temperature and non-aging neoprene rubber and/or black EPDM completely around the perimeter of the lens and around the rear wire entrance hole. Protects against dust, moisture and outside contamination.
11 = 8¼" Width x 11-1/8" Height x 4" Depth (ADA) 13 = 8¼" Width x 13¼" Height x 4" Depth (ADA) 16 = 8¼" Width x 16" Height x 5½" Depth 21 = 9¼" Width x 21" Height x 5½" Depth 26 = 12¼" Width x 26¼" Height x 7¼" Depth 41 = 14" Width x 41" Height x 8½" Depth
ADA Sizes 18-ADA = 8¼" Width x 18" Height x 4" Depth 21-ADA = 8¼" Width x 21" Height x 4" Depth 26-ADA = 8¼" Width x 26¼" Height x 4" Depth 30-ADA = 8¼" Width x 30" Height x 4" Depth
0-10D = 0-10V Low Voltage LED Dimming CA = Aluminum Backbox/Surface Conduit [2" deep] CLTB = Clear Top & Bottom (Standard with LU/LD) CM = Ceiling Mount (Custom Requirements) CU = Custom Requirements EM = Emergency battery (CA required)
- Specify Voltage [120V or 277V]
- Consult Factory for EM Options FUS = Fuse and Fuseholder DFUS = Double Fuse and Fuseholder GN = Generator Transfer Device H/L1 = High/Low Light Level for LED
-Single AC-Input Feed / Switch Sensor (Required) H/L2 = High/Low Light Level for LED
-Wired for Dual AC Input Feeds HOR = Horizontal Mount (Consult Factory) MD = Integral Motion Detector (Single Circuit)
-Specify "A" for Steps: 0% - 100% - 0%
-Specify "B" for Steps: xx% - 100% - xx%
-xx% = LOW Level and/or STANDBY Dimmed Levels
Options: 50% / 30% / 20% / 10% OTB = Opaque Top & Bottom OPTB = Open Top & Bottom (indoor only) PHT1 = Integral Photocell 120V [CA required] PHT7 = Integral Photocell 277V [CA required] PHTD = Integral Photocell Dual Voltage 277V [CA required] REM = Remote Emergency Battery
self-contained in CA – Must Specify Voltage [120V or 277V];
Consult Factory for REM Options SSDTB = Aluminum Solid Shield Top / Bottom (No Light) TPD = Tamperproof Screwdriver