Click to Enlarge Image
The Dark Sky Collection
ARLINGTON
  • Trapezoidal Aluminum Durable Case
  • Weather and Vandal Resistant Design 
  • Full-Cutoff Dark Sky® Compliant Luminaire
Download: Arlington Spec-Sheet
*Click +/- to expand/collapse information
  Product Specifications:
Backplate: Die Cast Aluminum.

Driver: Universal Voltage 120/277V Electronic Driver [UNV] is standard for LED.

Finish: Oven baked [BZ] bronze polyester powder finish.

Gasketing: High temperature black EPDM and neoprene rubber concealed in housing pocket & enclosed by cast in drip shield and rear wire entrance hole protects against dust, moisture and outside contamination.

Housing: Die cast aluminum. Wire access through .5" conduit size entry hole on back.

Lamp: [LED] Light Emitting Diode.

Lens: Clear Tempered Glass .187" thick Clear Polycarbonate Lens is optional.

Lens Fasteners: 2 Stainless steel tamperproof screws to secure lens in place.

Reflector: .032 prescription specular aluminum for high efficiency and reduction in arc tube voltage rise.

Compliance: Suitable for Wet Locations.

NOTE: *For Dimming and Emergency Options, please Consult Factory.

  Series:
AG = Arlington Series

  Sizes:
AG = 16¾" Width x 7" Height x 7" Depth 

  Distribution:
* Must Specify Distribution Style
FT =
Forward Throw
WT = Wide Spread Throw

  LED Wattages:
LED20 = 20 Watt LED
LED30 = 30 Watt LED
LED40 = 40 Watt LED

  Color Temperature:
CT3 = +/-3000K LED Color Temp
CT4 = +/-4000K LED Color Temp
CT5 = +/-5000K LED Color Temp

  Voltage:
120 = 120 Volts
277 = 277 Volts
347 = 347 Volts
UNV = 120~277 Universal Volt Electronic Driver
2UNV = Two 120~277 Universal Volt Electronic Drivers

  Ballasts:
EBX = Electronic Ballast
2EBX = Two Electronic Ballasts
EBMH = Electronic Ballast for MH
HPF = High Power Factor for MH

  Options:
CA = 2" Deep Aluminum Backbox/Surface Conduit
EM = Emergency Battery (Must Specify Voltage [120V or 277V]; *Consult Factory for EM Options)
FUS = Fuse and Fuseholder
FUS2 = Double Fuse
GN = Generator Transfer Device
H/L1 = High/Low LED Light Level
-Single AC-Input feed / Switch Sensor (Required)
H/L2 = High/Low LED Light Level
-Wired for Dual AC Input Feeds
MDX = External Motion Detector
-Specify "A" for Single Circuit: All On / All Off
-Specifiy "B" for Single Circuit: High / Low Light
(Specify Finish: Bronze or White)
PHTD = Integral Dual Voltage Photoecell 120/277V
REM = Remote Emergency Battery (self contained in CA - Must Specify Voltage [120V or 277V] *Consult Factory for REM Options)
SU = Surge Protection for LED Fixtures
TPD = Tamperproof Screwdriver
TPS = Tamperproof Screws

  Painted Finishes:
PA = Painted Aluminum 
BK = Black
BZ = Bronze
WHT = White