Driver 120 or 277 Volt, extreme temp range -30°C to 90°C, electronic driver [EBX].
Finish: Housing parts are 5-stage pre-treated and finished in white polyester powder coat. Optional Natatorium Coating [NTC] is available.
Housing: Extruded aluminum with internal reinforcements of double thick cast aluminum ends for the most strength and rigidness. Tamper-proof torx screws secure end caps. All metal parts are 5-stage pre-treated.
Lens Fasteners: 4 screws to secure lens in place (2 per side).
Reflector: Formed aluminum with multiple bends for max rigidness and unitising all electrical components.
Back Box: Back Box Conduit Adapter [CA] Option required for Integral and Remote Emergency Battery, and specific LED Wattages.
Compliance: Built according to U.S. and Canadian safety standards. Complies with Buy American Act. IP65 Rated and suitable for Wet Locations Covered Ceiling. Wall Mount - Damp Location; requires shielding to maintain wet listing.
Long Life: 50,000 Hour LEDs at L80 reduce life cycle maintenance cost.
NOTE: *For Dimming and Emergency Options, please Consult Factory.
120 = 120 Volts 277 = 277 Volts 347 = 347 Volts UNV = 120~277 Universal Volt Electronic Driver (Must Specify Voltage for EM Option) 2UNV = Two 120~277 Universal Volt Electronic Drivers (Must Specify Voltage for EM Option)
8DIM = LED Dimming Forward Phase (TRIAC) 13DIM = LED Step Dimming (Consult Factory) CA = Aluminum Conduit Adapter / Back Box (Required for Emergency Battery Options - Consult Factory for Specifics) CL = Clear Prismatic Polycarbonate Lens DLC = Design Lights Consortium - Compliant (PENDING) EM = Emergency Battery (Must Specify Voltage [120V or 277V]; *Consult Factory for Options) FUS = Fuse and Fuseholder FUS2 = Double Fusing GN = Generator Transfer Device H/L1 = High/Low LED Light Level
-Single AC-Input feed / Switch Sensor (Required) H/L2 = High/Low LED Light Level
-Wired for Dual AC Input Feeds MD = Integral Motion Detector (Single Circuit)
-Specify "A" for Steps: 0% - 100% - 0%
-Specify "B" for Steps: xx% - 100% - xx%
-xx% = LOW Level and/or STANDBY Dimmed Levels
Options: 50% / 30% / 20% / 10%
-Maximum Mounting Height of Fixture is 18 Feet PM = Pendant Mount [Two 12" Stems Standard] - *43.875 Distance (On Center) between Stems REM =Remote Emergency Battery (self contained in CA - Must Specify Voltage [120V or 277V] *Consult Factory for options) RMT = Wireless PIR Remote Control SU = Surge Protection for LED Fixtures TM = Tandem Mount - Specify Length: 8' or 12' or Custom WMSH = Wall Mount Shield
-Required for Outdoor Wet Location WMT = Wall Mount - Damp Only (Requires WMSH)