Click to Enlarge Image

Additional Images
The High Abuse Collection
ZEPHYR-CSTB
  • Drop Square or Drop Pyramidal Lens Options
  • Standard Shallow Cast Aluminum Backbox
  • High Abuse Wall or Ceiling Mount
Download: Zephyr-CSTB Series Spec-Sheet
*Click +/- to expand/collapse information
  Product Specifications:
Backplate: 16 gauge aluminum formed for rigidity.

Driver: 120 or 277 Volt universal voltage electronic driver [UNV].

Gasketing: 1-piece standard die cut .1875" thick black EPDM and/or neoprene rubber.

Ground Wire: Insulated green pre-attached wire.

Hardware: 2 J-BOX screws for indoor mounting.

Lamping: [LED] Light Emitting Diode.

Lens: Injection molded .125" thick clear prismatic polycarbonate completely enclosed fixture.

Lens Fasteners: 4 stainless steel tamperproof screws to secure lens to backplate.

Mounting Holes: 4 .3125" diameter holes for .25" diameter bolts. Carriage bolts must be used with conduit adapter.

Reflector: 16 gauge aluminum formed for rigidity.

Compliance: Built according to U.S. and Canadian safety standards. Suitable for Wet Locations.

NOTE: *For Dimming and Emergency Options, please Consult Factory.

  Series:
ZE-CSTB = Zephyr Cast Aluminum Series

  Max No. of Lamps/Wattages:
LED40 = 40 Watt Light Emitting Diode
LED60 = 60 Watt Light Emitting Diode (CA Option Required)

  Color Temperature:
CT3 = +/-3000K LED Color Temp
CT4 = +/-4000K LED Color Temp
CT5 = +/-5000K LED Color Temp
CT65 = +/-6500K LED Color Temp

  Voltage:
120 = 120 Volts
277 = 277 Volts
347 = 347 Volts
UNV = 120~277 Universal Volt (Must Specify Voltage for EM Option)

  Options:
0-10D = 0-10V Low Voltage LED Dimming
8DIM = LED Dimming Forward Phase (TRIAC)
CA = Aluminum Back Box Conduit Adapter [4.5" deep]
DSS = Drop Straight Sides Diffuser - Standard
DT = Drop Tapered Sides Diffuser [Standard]
FUS = Fuse and Fuseholder
FUS2 = Double Fusing
GN = Generator Transfer Device
H/L1 = High/Low Light Level for LED
-Single AC-Input Feed / Switch Sensor (Required)
H/L2 = High/Low Light Level for LED
-Wired for Dual AC Input Feeds
MD = Integral Motion Detector
-Specify "A" for Single Circuit: All On / All Off
-Specify "B" for Single Circuit: Half On / Half Off
MDX = External Motion Detector
-Specify "A" for Single Circuit: All On / All Off
-Specify "B" for Single Circuit: Half On / Half Off
-Specify White (WHT) or Bronze (BZ) Finish
OP = Opal White Diffuser
PHTD = Integral Dual Voltage Photocell 120/277V
PM = Pendant Mount (Specify Stem Length)
QMB = Quick Mount Galvanized "J" Box
REM = Remote Emergency Battery (self contained in CA - Must Specify Voltage [120V or 277V] *Consult Factory for REM Options)
SRM = Semi-Recessed Mount
SU = Surge Protection for LED Fixtures
TPD = Tamperproof Screwdriver

  Painted Finishes:
BK = Black
BZ = Bronze (Standard)
WHT = White
PA = Painted Aluminum
CC = Custom Color